DEV Community

GridCircuits
GridCircuits

Posted on

Motor Starting Voltage Dip: Why the Lights Flicker When a Big Motor Starts

When a large induction motor starts direct-on-line, it can draw five to seven times its full-load current for the first few seconds. That inrush flows through the source impedance — transformer, cables, and the grid behind them — and the voltage at the bus dips until the motor gets up to speed. On a stiff supply nobody notices. On a weak one, lights flicker, contactors can drop out, and other drives may trip on undervoltage.

A quick worked check

Say a 200 hp motor, roughly 240 A full load, starts across the line at six times full-load current: about 1,440 A of starting current, at a low starting power factor. If the supply transformer and feeder present enough impedance that this current pulls the bus down by, say, 12%, every other load on that bus feels the same 12% sag for the duration of the start. Whether that is acceptable depends on what else is running — a common rule of thumb is to keep the dip at the point of common coupling modest, and to check the motor itself still develops enough torque, because torque falls with the square of voltage. At 88% voltage the motor only makes about 77% of its rated-voltage starting torque.

What actually fixes it

The honest options are the familiar ones: a soft starter or VFD to limit inrush, a larger or lower-impedance transformer, starting the biggest motor first while the bus is unloaded, or simply confirming the dip is tolerable and short-lived. The wrong move is guessing — the dip is a straightforward impedance calculation, and it is worth doing before the motor is ordered, not after the complaints start.

Check your own numbers

If you want to run the same check with your own motor and supply, the free Induction Motor Starting Calculator on GridCircuits estimates starting current and bus voltage dip from the motor rating and source impedance. It shows the formula it uses, runs in your browser, and never uploads project data.

Top comments (0)